Question : Cisco 2500 : Can't get out of RXBOOT

Please help, I can't seem to get out of RXBOOT nor can I copy my IOS from a TFTP server.

System Bootstrap, Version 4.14(9.1), SOFTWAREBuffer*                                      
Copyright (c) 1986-1994 by cisco Systems
30F58       992 30D30   31360      1  
2500 processor with 1024 Kbytes of main me                                
       
Use, duplication, or disclosure by the Government is                          
31360       992 30F58  
subject to restrictions as set forth in subparagraph                                                    
(c) of the Commercial Computer Software - Restricted             10115D8   *Packet Buffer*2 31360   31B7
Rights clause at FAR sec. 52.227-19 and subparagraph                                                    
(c) (1) (ii) of the Rights in Technical Data and Computer              
113A10      960 113628  113DF8     1      
Software clause at DFARS sec. 252.227-7013.               101844E   *Init*            

              cisco Systems, Inc.                                
              1525 O'Brien Drive    


3000 Bootstrap Software (IGS-RXBOOT), Version 9.14(9), RELEASE SOFTWARE (fc1)
Patchlevel = 9.1(12.6)
Copyright (c) 1986-1994 by cisco Systems, Inc.
Compiled Wed 28-Sep-94 14:10 by chansen


ERR: Invalid chip id 0x80B5 (reversed = 0x1AD ) detected in System flash
cisco 2500 (68030) processor (revision A) with 1020K/1024K bytes of memory.
Processor board serial number 01439175
DDN X.25 software, Version 2.0, NET2 and BFE compliant.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Device not programmable)



Press RETURN to get started!


Answer : Cisco 2500 : Can't get out of RXBOOT

What is the size of the current chip in the router and the ship you are installing? See:

http://www.cisco.com/en/US/products/hw/routers/ps233/products_installation_and_configuration_guide_chapter09186a008007c830.html

These chips must be the same if you are going to put them both in at the same time.

on top of this, at this prompt to a 'enable' and a 'show flash' and post.

-sean
Random Solutions  
 
programming4us programming4us