Question : configure Unifed Call Manager Gateway IOS configuration

I Have configured the unified call  manager server route pattern using 9.@ , I need IOS commands for my gateway router to route calls over the fxo to the pstn.
The server and router use H.323.

Any help is appreciated.

Answer : configure Unifed Call Manager Gateway IOS configuration

Ok so when a call comes in you are plarring to 1009.  So we need to set up a dial peer to send 1009 to callmanger:

So do this:


no dial-peer voice 2000 voip

dial-peer voice 1009 voip
description primary ccm
preference 1
destination-pattern 1009
session target ipv4:x.x.x.x     <-- ip address of callmanager server
incoming called-number ..........
dtmf-relay h245-alphanumeric
ip qos dscp cs5 media
no vad