Question : Netware Client loop

1. Microsoft Windows Small Bus server 2003 (domain controller)
   - This was working fine before the install.
   - Logged into domain.
2. Installed Client 4.91 from novell.
   Logged in as workstation
   Loads personal settings
   Loggin off
   Saving Settings
   Client Login again

I would like to figure out a way to uninstall the novell client but because of the loop I can't not get to add\remove programs.
In safe mode I cant use the add\remove programs
In safe mode with command prompt I run the add\remove  .cpl file it does not recognize any installations.
I want the novell client removed. HOW?

Answer : Netware Client loop

I had a similar problem with an XP workstation just recently.  I used "workstation only" login (you should have a check box for it on the Novel login box), and logged in administrator.  Then I went to the network properties, and removed the client.  Rebooted, then re-installed the client and it's been working ever since.  Be sure to do a "custom" install, so you can tell it to only use the IP protocol (unless you are still suing IPX, in which case install only IPX; it will leave the IP stack untouched)

If you need to force the issue about the "workstation only" login, unlug the network cable and try to login.  After about 45-60 seconds, the login to NetWare will time out, and you will be asked if you want to log in workstation only.

Hope this helps.