Question : Dynamic voice and data Nxt1 with Cisco UC520 configuration

I going to be moving into a locaiton that has a dynamicvoice and data NxT1(PRI) the carrier is installing. The carrier is providing the cisco 1800 series router. I will most likley be getting a FE handoff from the carrier...How do I go about setting up the UC520 to handle this? The carrier will be doing the multililnk. I've done this with single T1's and a CSU, but if I'm not setting up the multilink, how would I go about setting up the UC520 to deal with this type of connection?

Answer : Dynamic voice and data Nxt1 with Cisco UC520 configuration

You just setup a VOIP dial peer to send outgoing voice traffic to the 1800. Below is an example of a sip trunk out configured on a UC 520

                       
             dial-peer voice 40 voip
 description sip trunk
 destination-pattern 91[2-9]..[2-9]......
 session protocol sipv2
 session target ipv4:10.1.1.10
 dtmf-relay sip-notify
 codec g711ulaw
 no vad

Open in New Window

Select All