Question : Asterisk: Installing a 2 fxo digium Card

I have been using a trixbox installation on a network of phones for the last few days to contact each host phone. I would like to direct calls to and from pots lines also so i purchased a digium 2 fxo card. I have been using the trixbox interface to create the extensions and call setups. I need help making sure that the asterisk/trixbox module sees this device and also I'd like to know how to set up the inbounds and outbounds from the interface also. The version of trixbox is its latest release v2.6.1

here is the output from a lspci. it shows the digium installed

00:00.0 Host bridge: Silicon Integrated Systems [SiS] 651 Host (rev 02)
00:01.0 PCI bridge: Silicon Integrated Systems [SiS] Virtual PCI-to-PCI bridge (AGP)
00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS962 [MuTIOL Media IO] (rev 14)
00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE]
00:02.7 Multimedia audio controller: Silicon Integrated Systems [SiS] AC'97 Sound Controller (rev a0)
00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 0f)
00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 0f)
00:03.2 USB Controller: Silicon Integrated Systems [SiS] USB 1.0 Controller (rev 0f)
00:03.3 USB Controller: Silicon Integrated Systems [SiS] USB 2.0 Controller
00:0a.0 Ethernet controller: Digium, Inc. Wildcard TDM800P 8-port analog card (rev 11)
00:0f.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
00:10.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller (rev 46)
01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS] 65x/M650/740 PCI/AGP VGA Display Adapter

Answer : Asterisk: Installing a 2 fxo digium Card

If you run the command 'lsmod' it will show which modules are installed which will tell you that zaptel and the module for the specific card you have loaded ok.