Question : SSh with hp procurve 4100G

I cant seem to figure the solution to this issue:

I have confugred my procurve siwtches to use ssh as we were using telnet and it is not secure.... So now when I ssh into any of the procurves it goes to a prompt and forces you this screen below:

HP J4887A ProCurve Switch 4104GL
Firmware revision G.07.70

Copyright (C) 1991-2005 Hewlett-Packard Co.  All Rights Reserved.

                           RESTRICTED RIGHTS LEGEND

 Use, duplication, or disclosure by the Government is subject to restrictions
 as set forth in subdivision (b) (3) (ii) of the Rights in Technical Data and
 Computer Software clause at 52.227-7013.

         HEWLETT-PACKARD COMPANY, 3000 Hanover St., Palo Alto, CA 94303




Press any key to continue


No I can get past this and login fine but the problem is , forget about using any scripts to automate config rollouts og any kind. This is only with ssh as telnet does not do this.?? Does anybody have any clue on a way around this?? I have never seen this on any other device. I have cisco's , Junipers, foundy, and F5 and they do not  do this??

Answer : SSh with hp procurve 4100G

What exactly is the problem?  That the device requires a single character be sent before proceeding?  Or do your scripts have problems actually logging in via ssh?  Are you writing your own scripts, or using some sort of admin package, etc?
 
giltjr - looks like we are receiving the same question notifs ;-)
 
Curious,
-Jon
Random Solutions  
 
programming4us programming4us