Question : NT4.0 Server setup

No matter what I do, installation of networking components in NT4.0 server fails with this error:

The network failed to start (0x0000042a)

During the setup, under Show bindings for, the area is emtpy.  Even though I have TCP/IP selected.   If I select NWlink then it shows the bindings for NWlink but of course I have a TCP/IP network.

NT4.0 is sketchy in my mind.   What am I missing?    How can I get these networking components installed.  

Major points for the right answer!

Answer : NT4.0 Server setup

Get the oldest NIC with NT4 drivers that you can find. Newer NIC's may not support NT4 at all.

I hope this helps !