|
Question : Static Route Help - See my diagram
|
|
Please check out my diagram: http://www.basherdesigns.com/ht/Linksys-VPNs.jpg
I am in need of some static route advice. Currently Wentzville can communicate with Lake St. Louis thru 2 Linksys VPN routers (BEFVP41 V2) vpn tunnel on a wireless internet connection. Lake St. Louis can communicate with St. Peters thru 2 FreeBSD firewalls vpn tunnel on a T1 at each location. What I need to do is allow Wentzville to talk to St. Peters, probably going to Lake St. Louis then to St. Peters over the FreeBSD VPN. What would be the correct static routes for these devices. Can someone please give this route puzzle a shot!
Thank you!!
|
Answer : Static Route Help - See my diagram
|
|
You'd need to add a route to 10.3.3.0 which points to the Linksys VPN Router (or any router) at Lac St. Louis (which in turn ought to route to St. Peters).
This might not work with your VPN setup because the FreeBSD VBN at Lake St. Louis might not be configured to send traffic from 10.5.5.0. If that's the case, you might need to translate the 10.5.5.0 address to 10.4.4.0 addresses before they can go over the VPN tunnel.
|
|
|